Skip to content
0 Cart

AUTOFIX / Service desk

Size & fit guide

Our mats, liners and covers are universal sizes. How to measure your car in five minutes and compare it with our listings.

Universal sizes. Our mats, liners, seat covers and wheel covers are not made for a specific vehicle make or model. Five minutes with a tape measure is the best way to avoid a return.

Steering wheel covers

  1. Measure straight across the wheel from the outer edge on one side to the outer edge on the other side, through the centre. This is the outer diameter.
  2. Our covers fit wheels with an outer diameter of 37–38 cm, which is common on many cars. Wheels outside this range will be too loose or too tight.
  3. Flat-bottomed wheels and very thick sports rims may not suit a stretch-on cover.

Floor mats

  1. Measure the driver’s footwell at its longest point (from the base of the pedals to the seat rail) and its widest point.
  2. Compare with the mat size on the product page. Mats with trim guides can be cut down, but not made bigger.
  3. Make sure the mat will lie flat and cannot slide under or against the pedals. Never lay a mat on top of another mat.

Boot liners and boot protectors

  1. Measure the depth of the boot floor, from the rear seat back to the boot opening.
  2. Measure the width at the widest point and between the wheel arches.
  3. Our trimmable liner is about 110 × 90 cm; the folding protector covers about 100 × 100 cm plus a 45 cm bumper flap.

Seat covers

  • Check your vehicle handbook: do not fit covers over seats with side airbags unless the handbook allows it.
  • Our covers suit seats with removable headrests. Integrated sports seats may not fit.
  • For the nine-piece set, check whether your rear bench is split; the zipped sections suit common split layouts.

Holders and small tools

ItemWhat to measureOur size
Cup holder expanderInside diameter of your cup holderBase fits about 6.5–8.5 cm
Cup holder phone mountInside diameter of your cup holderBase expands about 6.5–9 cm
Magnetic vent mountVent styleHorizontal slats only, not round vents
Vacuum nozzle kitOutside diameter of your vacuum hose endAdapter fits about 30–38 mm
Seat gap fillerWidth of the gap beside the seatAbout 9 cm wide, soft sides

Still not sure?

Email your measurements, or a photo with a tape measure in view, to support@autofixservices.shop and we will tell you honestly whether the item suits your car.